Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hub and spoke configuration

Hi,

I have a customer who have 5 sites. One site is a central site and all other sites should communicate with each other accross the central site. But on each spoke site there is two VLANs and thay also should communicate accross central site.

On PE routers I should configure vrf for every LAN. Than I would have 10 or more vrf.

Is there some other solution to split traffic from one site to go first to central site and than come back to CPE router? Some sites are on the same PE's.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: Hub and spoke configuration

Unfortunately, I don't believe there is any other way of doing this. As soon as you place two interfaces in the same VRF, traffic from one interface to the other will shortcut through the VRF and not traverse the hub site.

I'm afraid you are stuck with configuring one VRF per link.

Hope that helps - pls rate the post if it does.

Paresh

2 REPLIES
Purple

Re: Hub and spoke configuration

Unfortunately, I don't believe there is any other way of doing this. As soon as you place two interfaces in the same VRF, traffic from one interface to the other will shortcut through the VRF and not traverse the hub site.

I'm afraid you are stuck with configuring one VRF per link.

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: Hub and spoke configuration

Thanks

294
Views
0
Helpful
2
Replies