I'm having some drops in the circuit emulation between BTS and BSC connection. Did a ping from the BTS router to the BSC router and there is no packet loss ou high delay. Could someone help? I'm finding that the drops are being caused by jitter, there is a link with DWDM transmission in the middle. Perhaps the DWDM is not configured correctly.
ping X.X.X.X size 1600 df-bit
Type escape sequence to abort. Sending 5, 1600-byte ICMP Echos to 10.209.82.34, timeout is 2 seconds: Packet sent with the DF bit set !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/8 ms
show cem platform CEM0/0:0 errors: Last cleared 1w5d CEM0/1:0 errors: num_output_pkt_drop =========== 48135/228333357 MissingPkts ================= 3480 Jitter_buffer_Underruns ===== 37009 MisOrderDropped ============= 113 Jitter_buffer_Overruns ====== 7533 Last cleared 2d15h
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...