Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Implementing MPLS into a Traditional ATM Network

Is it possible to enable MPLS in a LS1010 interface that already has PVC configured?

  • MPLS
1 REPLY
New Member

Re: Implementing MPLS into a Traditional ATM Network

Hi,

I didn't use LS1010 before and don't know the answer of your question. But basically I can say that any ATM swith is NOT a MPLS enabled ATM switch. An ATM switch must run IP protocol to operate as an MPLS enabled ATM swicht. Pure ATM swicthes can't do it. On the cell mode operation ATM switch builds a control PVC (default 0/32) and over this PVC it creates LDP session to other equipment. So the software should also support this type of operation.

Regards

137
Views
0
Helpful
1
Replies
This widget could not be displayed.