The "no mpls ip propagate-ttl" only needs to be configured on the PEs but it not really an issue to configure it on the P. In principle, you should only see the ingress PE and egress PE in the traceroute. Are you tracing from a CE or from the PE? What platform and what version are you using?
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) firstname.lastname@example.org México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...