I am Enabling Backbone Routers to Collect Traffic Matrix Statistics (TMS) Data. I am not sure if i am suppose to place the command on the main interface or on the sub-interfaces in oreder to collect the data. both interfaces takes the command but i need to verify which would be approriate assuming that i have a main interface with a sub-interface point-point or multi-point.eg.
Thanks Waris, I have already done so but i needed confirmation as I also had channelized STM1 circuits. I am also wondering with ADSL, I have several point-point interface for ADSL specifying a PVC bounding all PPP to a Virtual Template, is it necessary to place the "ip cef accounting non-recursive external" on the virtual template or just leave it on the main ADSL ATM point-point interface on the PE.
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?