Is there anybody knows how the maximum bandwidth for an MPLS TS link is calculated? Litterature seems to indicate that it corresponds to interface bandwidth command but I do not think that this is the case.
pauillac#show ip ospf mpls traffic-eng link
OSPF Router with ID (18.104.22.168) (Process ID 100)
Area 0 has 2 MPLS TE links. Area instance is 6.
Links in hash bucket 8. Link is associated with fragment 1. Link instance is 6 Link connected to Broadcast network Link ID : 10.1.1.2 Interface Address : 10.1.1.1 Admin Metric te: 1 igp: 1 Maximum bandwidth : 12500000 Maximum reservable bandwidth : 64000 Number of Priority : 8 Priority 0 : 64000 Priority 1 : 64000 Priority 2 : 44250 Priority 3 : 44250 Priority 4 : 44250 Priority 5 : 44250 Priority 6 : 44250 Priority 7 : 44250 Affinity Bit : 0x0
The maximum bandwidth for a 100 Base T interface is 12500000 and 1250000 for a 10 Base T interface. In fact, it seems that the interface bandwidth is multiply by 125.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...