I have two questions here if anybody can through some light on this.
Q1) How do I assign a dynamic IPv6 address to a PPP Session via RADIUS. Only way I could get the IPv6 address assigned to the client is via a local IPv6 Prefix pool on the Access Server. Using local pools is impossible to manage if the remote devices are managed CPE's.
Q2) When I have a PPP session attached to my access server using IPv6, when I issue the "show users" command, I can see that the user is attached to a virtual access interface but the IPv6 address is not displayed as it does when using IPv4.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...