Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

L2 VPLS 7206VXR

I am configuring 7206VXR (IOS 12.4(11)T); as the following:

7206(config)#l2 vfi VPLS-Test ?

point-to-point Point-to-point configuration mode

for l2 vpls there is only one option p-to-p, i can't find manual option on this IOS!! do i need to change this ios or what?

The command should be like this #l2 vfi VPLS-Test manual. Becuase using p-to-p option i can configure only 2 peers.

Any work around?

Regards

1 REPLY
Silver

Re: L2 VPLS 7206VXR

Mustafa

7206 doesnot support VPLS. For VPLS configuration minimum requirement is 7600 with sip/spa card. On 7206 you can configure only point to point l2 circuits.

If would be better to create a psudowire and bind it to some interface.

regards

shivlu jain

725
Views
5
Helpful
1
Replies