Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

L2VPN Interworking Problem

There is a scenario:

(CE1)7600-----FE VLAN(dot1q)-----(PE1)7200VXR(NPE300)----FE----(PE2)7200VXR(NPE400)----atm----(ATM cloud)------frame relay------(CE2)2811

I want to bridge traffic between Ethernet interface to ATM interface on PE Router Cisco7200 with L2VPN Interworking.I used the IP mode interworking, VC is UP, I'm trying to ping from 7600 to 2811,it can't work.I want to know why? if you have any other suggestion to make the L2VPN Interworking configuration on 7600 to 2811 , please advise.

Thanks in advance

1 REPLY
New Member

Re: L2VPN Interworking Problem

Hi mate,

I think you need to configure Frame-Relay to ATM service interworking between PE2 & CE2.

Kindly refer below given link:

http://www.cisco.com/en/US/products/hw/switches/ps1893/products_configuration_guide_chapter09186a00800f375b.html#1010548

Regards

Ritesh

282
Views
0
Helpful
1
Replies
CreatePlease to create content