04-02-2013 03:30 PM
Hello Can any body advise how can I enable LDP on IOS XR interface BVI , when I type
mpls ldp
interface ?
I can not see BVI in the list .
I have even tried to use the autoconfig command under ospf but no joy , it does not show up when you type "Show mpls interface"
George Kamel
Solved! Go to Solution.
04-03-2013 03:31 AM
Yes, sure.
Create a L3 subinterface with encapsulation dot1q and enable mpls ldp for this subinterface.
You can check how to create dot1q subinterface here:
http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/interfaces/configuration/guide/hc42vlan.html
Cheers
Sent from Cisco Technical Support iPad App
04-02-2013 04:53 PM
It is currently not supported.
Cheers
Sent from Cisco Technical Support iPad App
04-03-2013 02:52 AM
ok , in that case is there an other way on XR I can create an interface that genereate dot1q tagged traffic and support mpls as well ?
04-03-2013 03:31 AM
Yes, sure.
Create a L3 subinterface with encapsulation dot1q and enable mpls ldp for this subinterface.
You can check how to create dot1q subinterface here:
http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/interfaces/configuration/guide/hc42vlan.html
Cheers
Sent from Cisco Technical Support iPad App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: