Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LER to LER Eompls setup

Hi All

I have the scenario below:

PC1----eth---Cisco ASR1004(1)---stmx link------CiscoASR1004(2)----eth---PC2

I would like to use eompls so that pc1 and pc2 are in the same subnet.

I have configured the xconnect on a vlan subinterfaces enabled mpls with targetted ldp and enabled it on the pos cards but neither pc can ping the other.

On both routers sh mpls l2transport vc  displays status up

I would like to know if using the 2 routers as edge and directly connecting them to each other is implaussible.

Thanks in advance.

Everyone's tags (2)
3 REPLIES
Cisco Employee

Re: LER to LER Eompls setup

Hi,

Are the PC's directly connected to the ASR1k ?

Thanks

Laurent.

Community Member

Re: LER to LER Eompls setup

Hello Laurent,

We have extreme networks switches connected on both sides. This are basically configured with vlan tagged on asr side and untagged on P.C side.

Regards

Cisco Employee

Re: LER to LER Eompls setup

Hi,

Please post the complete configuration of both ASR1k and the ouput of sh mpls l2transport vc detail

Thanks

Laurent.

755
Views
0
Helpful
3
Replies
CreatePlease to create content