I have a LDP session b/w two routers with 2 LSPs, one with direct ptp E1 & other is through GRE tunnel. The per session load balancing seems to achieve.
I am running L2VPNs (EoMPLS) through this session. The problem is, using both LSPs, few circuits are able to ping & through but some are not. Means complete connectivity is not there. When i remove LSP path from GRE, it works fine.
The MPLS Traffic Engineering-LSP Attributes feature is an extension to MPLS TE that provides an LSP Attribute List feature and a Path Option for Bandwidth Override feature. These features provide flexibility in the configuration of LSP attributes for MPLS TE tunnel path options. Several LSP attributes can be applied to path options for TE tunnels using an LSP attribute list. If bandwidth is the only LSP attribute you require, then you can configure a path option for bandwidth override.
Refer the following url for more information on MPLS Traffic Engineering - LSP Attributes:
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...