Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

LSP Traffic Counters Not Working in IOS

Hi,

We are in the process of building traffic matrix in our network to analyze and use for our forecasting the network growth.

I am planning to make use of LDP traffic statistics counters to determine traffic flow between PE routers i.e. per LSP. Only LDP is used for LSP formation not RSVP-TE. I am making use of the CLI "show mpls forwarding-table <prefix>" which lists the "Bytes tag switched" but the counters are not increasing.

C7206-NPE-G2#sh mpls for a.b.c.d

Local  Outgoing    Prefix            Bytes tag  Outgoing   Next Hop

tag    tag or VC   or Tunnel Id      switched   interface

719    16697       a.b.c.d/32   0          Gi0/2      x.x.x.x

I tried by doing a ping from the local router to the destination and traffic is flowing through the LSP. Even tried pining a L3 MPLS VPN customer connected between source and destination routers, but still the counters are not increasing.

Platform and IOS version in use are: 7206 NPE-G2 and c7200p-spservicesk9-mz.124-15.T12.bin.

I would like to know

1. whether use of "LDP traffic statistics" work for my requirement.

2. any known issues in IOS with the above command i.e. could this be related to software defect

thanks in advance

Arun

260
Views
0
Helpful
0
Replies
CreatePlease to create content