Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Migrating Interface from Global to VRF

Hi All,

We are trying to move interfaces from global routing table to VRF interface and during that process we are trying to move eigrp belonging to that interface from Global configuration to Address-family ipv4 instance of the eigrp under the VRF .

We are trying to figure out to populate passive-interface command under the address-family ipv4 vrf .But couldn't find the command supported in 12.2(18)SXF15 for Cisco 7600 router. Do we have to configure the passive-interface command alone in the global eigrp instead of address-family ?. Any help would be really appreciated.

Thanks

Regards

Anantha Subramanian Natarajan

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Migrating Interface from Global to VRF

Anantha,

"passive-interface" under the "address-family" is only available starting with 12.2(33)SRB.

In the version you are currently running, configuring "passive-interface" globally will take effect even for specific VRF interfaces though.

Regards

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
2 REPLIES
Cisco Employee

Re: Migrating Interface from Global to VRF

Anantha,

"passive-interface" under the "address-family" is only available starting with 12.2(33)SRB.

In the version you are currently running, configuring "passive-interface" globally will take effect even for specific VRF interfaces though.

Regards

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
New Member

Re: Migrating Interface from Global to VRF

Thank You hritter

Regards

Anantha Subramanian Natarajan

188
Views
0
Helpful
2
Replies
CreatePlease to create content