Can someone assist me in the configuration, with the configuration of Two MPLS TE tunnels. This is how the network should work.
Some details of the topology can be found below.
PE - 1 loopback = 220.127.116.11
P1 = loopback = 18.104.22.168
P2 = loopback = 22.214.171.124
P3 = loopback = 126.96.36.199
PE2 = loopback = 188.8.131.52
Now what i need to do is configure two MPLE TE tunnels the primary tunnel should transport traffic Path 1 = PE-1, P1, P2, PE-2
The second Tunnel should transport traffic via Path 2 PE-1,P1,P3,P2, PE2.
Path will always act as the primary, path two will be the secondary, I want Tunnel 2 two also act as a backup if the link between P1 and P2 were to ever go down. Would be nice to have a FRR for tunnel two.
Help With this would be much appreciated. Please find topology attached. Please find current configurations attached, please ignore the GRE IPSEC tunnels in the configurations these were put in place because i wanted to encrypt traffic between all the nodes in the provider network.
For now all i need is assistance in building two tunnels between the provider routers. Topology attached.
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?