Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

MPLS and bridging over FR

Has anyone seen this message:

The bridge-group command is unsupported on the interface:Serial2/0:0.24

when the MPLS feature has been enabled on

the main interface or one of its subinterfaces:Serial2/0:0.2

It used to work in 12.2, but after upgrade to 12.3.5b it's not.

I didn't find anything in the documentation about this problem.

Any help is appreciated.

  • MPLS
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: MPLS and bridging over FR

The combination of these two features is unsupported and has caused problems in the past. A check has been implemented by CSCdz75507, which will prevent the configuration of "bridge-group" if MPLS is configured or vice versa.

Hope this helps,

1 REPLY
Cisco Employee

Re: MPLS and bridging over FR

The combination of these two features is unsupported and has caused problems in the past. A check has been implemented by CSCdz75507, which will prevent the configuration of "bridge-group" if MPLS is configured or vice versa.

Hope this helps,

117
Views
0
Helpful
1
Replies