Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

MPLS and Multicast

I have an issue getting multicast run across an MPLS Backbone, in a test lab. When all PE's are in the same AS all works fine, 4 PE's in a ring topology. If I reconfigure each PE into a seperate AS, .i.e. AS1, AS2, AS3, AS4. Multicast stops working and the mdt tunnesl are not built.

Using the same as, the mdt tunnels are built and all works ok.

Is there extera configuration to be done wo have the mdt tunnels established across different AS's

D

1 REPLY
Cisco Employee

Re: MPLS and Multicast

Currently being discussed in this other thread:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Service%20Providers&topic=MPLS&topicID=.ee8558c&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc1dbab

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
171
Views
0
Helpful
1
Replies
CreatePlease to create content