Iam enabling MPLS (LDP) on the backbone of my network. The connected routers are 7613 at the central location and 7200 at remote location. Both sides the e1 termination are on Channelised E1 ports
The topology is attached
The moment I enable ldp neighborship bet the routers i loose connectivity to the remote location routers ethernet and loopback ips. But all the device in the remote location lan say other routers switches and pcs are reachable
I suspect some mtu issues
Commands used globally are
mpls ip
mpls label protocol ldp
Interface level (serial interface)
mpls ip
mpls label protocol ldp
Some help is appreciated