I have some confusion about the sample configration:
1) ASBR2 propagtes ff (PE2 loopbak address)route and lable to ASBR2
,wheather asbr1 would allocate a new lable to ff and send it to the rr1?
2) How many layer lables the pe1 shall add to the vpn stack in order to reach the destination behinde PE2?I think it should three layers (one for VPN,one to destination ff which is assinged by ASBR1 and the third layer is lable to xx which is the ASBR1?
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...