02-12-2007 04:31 AM
Is it possible to configure TE on a Port-Channel ?
I don't see the command mpls traffic-eng tunnels
CSCO-CORE-SPO(config-subif)#mpls ?
accounting Enable MPLS accounting on this interface
bgp MPLS BGP
ip Configure dynamic MPLS forwarding for IP
l2transport Layer 2 packet over MPLS config commands
label Label properties
ldp Configure Label Distribution Protocol (LDP) parameters
mtu Set MPLS Maximum Transmission Unit
netflow Configure Egress Netflow Accounting
CSCO-CORE-SPO(config-subif)#mpls tr
CSCO-CORE-SPO(config-subif)#mpls
02-14-2007 09:22 PM
Hi,
what software do you use ?
Rgds
Andreas
02-15-2007 03:37 AM
s72033-advipservicesk9_wan-mz.122-33.SRA2.bin
02-15-2007 06:14 AM
Try:
interface GigabitEthernet1/2
channel-group 1 mode active
!
interface GigabitEthernet1/3
channel-group 1 mode active
!
interface Port-channel 1
switch-port
switch-port access vlan 1507
switch-port mode access
!
interface vlan 1507
mpls traffic-eng tunnels
mpls traffic-eng backup-path Tunnel1
mpls ip
Rgds
Andreas
02-15-2007 07:42 AM
Hi Andreas, the port-channel must be L3 in my topology.
Cisco told me doesn't support yet link bundling in MPLS TE (http://www.ietf.org/rfc/rfc4201.txt).
02-15-2007 08:09 AM
if you can't change to that config, use 12.2.18.sxf 5 or wait until it is supported in SR.
Rgds
Andreas
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: