Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MPLS on Port-Channel

Is it possible to configure TE on a Port-Channel ?

I don't see the command mpls traffic-eng tunnels

CSCO-CORE-SPO(config-subif)#mpls ?

accounting Enable MPLS accounting on this interface

bgp MPLS BGP

ip Configure dynamic MPLS forwarding for IP

l2transport Layer 2 packet over MPLS config commands

label Label properties

ldp Configure Label Distribution Protocol (LDP) parameters

mtu Set MPLS Maximum Transmission Unit

netflow Configure Egress Netflow Accounting

CSCO-CORE-SPO(config-subif)#mpls tr

CSCO-CORE-SPO(config-subif)#mpls

5 REPLIES
New Member

Re: MPLS on Port-Channel

Hi,

what software do you use ?

Rgds

Andreas

New Member

Re: MPLS on Port-Channel

s72033-advipservicesk9_wan-mz.122-33.SRA2.bin

New Member

Re: MPLS on Port-Channel

Try:

interface GigabitEthernet1/2

channel-group 1 mode active

!

interface GigabitEthernet1/3

channel-group 1 mode active

!

interface Port-channel 1

switch-port

switch-port access vlan 1507

switch-port mode access

!

interface vlan 1507

mpls traffic-eng tunnels

mpls traffic-eng backup-path Tunnel1

mpls ip

Rgds

Andreas

New Member

Re: MPLS on Port-Channel

Hi Andreas, the port-channel must be L3 in my topology.

Cisco told me doesn't support yet link bundling in MPLS TE (http://www.ietf.org/rfc/rfc4201.txt).

New Member

Re: MPLS on Port-Channel

if you can't change to that config, use 12.2.18.sxf 5 or wait until it is supported in SR.

Rgds

Andreas

212
Views
0
Helpful
5
Replies
CreatePlease login to create content