I have to migrate DC DR and 1000 branch office to MPLS.
At present there is 3 tier architecture i.e. DC & DR, 10 Network aggrigation point and 100 branch office connected to each NAP. Between DC DR and NAP, MPLS connectivity and NAP to Brach office point to point connectivity. OSPF is routing protocol for entire network. PE-CE link is OSPF.
Now we are migrating on MPLS with 2 ISP connectivity with BGP as routing protocol.
Can I configure both OSPF and BGP on PE-CE link at DC and DR MPLS connectivity? So I can migrate the branch office to MPLS with BGP routing at PC-CE mpls link.
IntroductionPre-requisite: Caveat :When IPXE Boot could be done : IPXE Boot :Ipxe boot using DHCP Server :
iPXE boot in ASR9K
Migration recommendation document for Cxr to Exr.
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...
Hi community,I just wanted to share my findings about accesing to ACL counters by SNMP on ASR9000/XR.
Searching on Internet I found the section ACL Counters Using SNMP in the IP Addresses and Services Configuration Guide but I didn't found any inf...