I would like to start using NAT on our PE nodes but I cannot get it working. I have a lab setup with two vrf's terminating on the same node. In the lab I would like to NAT an address(Arguments sake a server) in the one VRF (Customer-C) to a unique address so that the other VRF (Customer-B) is able to reach this server via this address. I have the NAT statements in place and if I do a sh ip nat trans the nat shows up as active but if a I do a sh ip nat trans vrf there is nothing.
These are the commands I used:
ip nat pool inside1 184.108.40.206 220.127.116.11 netmask 255.255.255.0
ip nat inside source list test-nat pool inside1 vrf Customer-C
ip nat outside source static 18.104.22.168 22.214.171.124
ip access-list extended test-nat
permit ip 126.96.36.199 0.0.0.255 any
What am I doing wrong ? Any help would be appreciated.
I am not sure how you are attempting to make Customer B communicate with Customer C if you are using separate VRFs for them. There will not be any interaction between them unless they both tegether form a VPN with their routes contained in a single VRF. Once this is done, you can try to troubleshoot the NAT configuration.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...