I'm working on MPLS - (lab) and I was wondering how is it possible (or command) to pass traffic to and from the same AS? In my lab I have to specifiy "nei allow-as in" in order to see routes from routers in my AS. I have 5 routers in my lab - One in AS 777 mpls and the other four in AS 6500). Everything in AS 6500 has the bgp sub command neig "ip addy" allow-as in. This is the only way I can see routes advertised from neighbors.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...