I need an information: on a 7206vxr (ios 15.2S) I tried to configure an mpls-te over an etherchannel link but it doesn't seems to work (the TE tunnel never go up and the "show mpls traffic-eng tunnel tunnel 0 det" show the reason as "invalid path" but I guarantee that it's absolutely valid).
I tried to search into feature navigator but I don't found any of that: It figure out as 7206 don't support it, it's right?
In the IOS feature navigator the feature "MPLS TE - Bundled interface support (EtherChannel and MLP)" seems to be available only in 7600 platform and not in 7200 series. And with 7200 series I have had some difficulty with MPLS TE in a port-channel interface.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...