05-18-2009 12:42 AM
Hi,
I am working about MPLS TE. The MPLS TE book's say that is not a good idea to configure TE tunnel per VPN. Do you know otherwise if it's possible? How to forward VPN 1 flow (VRF_1) in one tunnel and VPN 2 in another tunnel ? Do you have an idea? For me, it's seems not possible via static or autoroute because the next-hop (Loopback for the remote PE) remain the same for all VPN.
Thanks for helping me.
Solved! Go to Solution.
05-18-2009 11:57 AM
Guillaume,
You can actually change the BGP next hop you receive from the remote PE for each VPN by using the following command:
ip vrf test
bgp next-hop
This way you can statically point each next hop to a different tunnel thus leading to a different tunnel for each VPN.
Regards
05-18-2009 11:57 AM
Guillaume,
You can actually change the BGP next hop you receive from the remote PE for each VPN by using the following command:
ip vrf test
bgp next-hop
This way you can statically point each next hop to a different tunnel thus leading to a different tunnel for each VPN.
Regards
05-18-2009 12:01 PM
Forgot to mention that the BGP next-hop command would be configured under the VRF context on the remote PE.
Regards
05-19-2009 07:31 AM
Thanks,
It remains just to configure the recursive routing to the next-hop. Forward the trafic down the tunnel (1 static route for each tunnel to Lo)
Guillaume
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: