Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MPLS TE Tunnels configuration

Hello.

I have the following doubt. What happens if I configure one TE tunnel in both ends. I have read that is enough configure only one side.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: MPLS TE Tunnels configuration

The LSP starts on PE on which Tunnel was built and ends on some ther PE, and its unidirectional. To have bidirectional you need to make two Tunnels on each end.

HTH,

Gaurav Prakash

2 REPLIES
New Member

Re: MPLS TE Tunnels configuration

The LSP starts on PE on which Tunnel was built and ends on some ther PE, and its unidirectional. To have bidirectional you need to make two Tunnels on each end.

HTH,

Gaurav Prakash

New Member

Re: MPLS TE Tunnels configuration

Thank you Gaurav.

253
Views
0
Helpful
2
Replies