I've manaeged to run and encrypt PE to PE traffic which is MPLS labeled throughout my network, I now need to look at a way of routing the traffic using MPLS TE tunnels for traffic engineering purposes is this possible. I've checked other forums and seen that it should be possible. But i just need to consider the MTU sizes. I'll set the MTU sizes to 1600 this should be fine.
Can someone explain the path the transported traffic will take. Because i was under the impression that the traffic will traverse the MPLE TE tunnel, But then i need the traffic to go via the GRE IPSEC which I've configured.
MPLS TE is Turning on MPLS TE over your encrypted GRE tunnels how is this done. I already have a full mesh of GRE IPSEC Tunnels between nodes. How would I use MPLS TE to transport encrypted GRE traffic an example would be nice.
I'll send the topology below.
The tunnels should have two alternative paths. a primary path and a secondary path.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...