MPLS Traffic engineering show mpls forwarding lsp tunnel deatil
Hi to Everybody
I am running 7200 Software (C7200-ADVIPSERVICESK9-M), Version 12.4(24)T3, RELEASE SOFTWARE (fc2) and I have configured a tunnel that is up and running but the following command does not show any output:
PE1#show mpls forwarding-table lsp-tunnel detail
Local Outgoing Prefix Bytes Label Outgoing Next Hop
Label Label or VC or Tunnel Id Switched interface
Is there anybody knows why this command does not provide any output. What would be the best way to find out the outgoing label for tunnel 100.
Last question, how many MPLS label are required to send traffic to a tunnel?
ip unnumbered Loopback0
no clns route-cache
tunnel destination 126.96.36.199
tunnel mode mpls traffic-eng
tunnel mpls traffic-eng autoroute announce
tunnel mpls traffic-eng path-option 1 explicit name PRIMARY
tunnel mpls traffic-eng fast-reroute
no routing dynamic
PE1#show mpls traffic-eng tunnels brief
LSP Tunnels Process: running
Passive LSP Listener: running
RSVP Process: running
Periodic reoptimization: every 3600 seconds, next in 2415 seconds
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...