You also need "mpls ldp discovery targeted-hello accept" on the other router.
Another possibility would be to use MPLS TE tunnels with FRR and run LDP over those tunnels (LDP over RSVP) so protect your LDP traffic. Although it would work, its a bit more complex solution but TE does offer the best recovery times for traffic.
when I use auto-tunnel pri and back, even though I use POS sdh I still see some packet loss over MPLS VPN, and find out auto-tunnel Te for MPLS VPN converge is much slower than tunnel backup, but it is very tedious to manually configure backup tunnels.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...