Kindly please refer to the diagram on the url. Now, please refer to the configuration of Rapid and Pivrnec routers. RIP is configured and Loopback IPs,WAN IPs are declared but in Rapid router "ip route 188.8.131.52 255.0.0.0 Null0" and Pivrnec router "ip route 184.108.40.206 255.0.0.0 Null0" are used instead of advertising these using the network command. My question is why are these networks not advertised as loopback IPs and WAN IPs are advertised using network command. Kindly please help me out of this...
Re: MPLS VPN over ATM: with BGP or RIP on the Customer Site
I'm not sure I understand your question. You are right by saying that these routes could have been generated using a network statement. My guess is that they wanted to show alternate ways of doing things. Could you clarify.
Hope this helps,
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) firstname.lastname@example.org México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...