Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

MPLS VPN Traffic Issue

I have a functioning MPLS VPN configured. We had our core router reboot this morning. When this happened, The MPLS VPN didnt come up correctly. We see traffic passing on the main vpn. We see a full route list on the VRF, however it wont pass any traffic.

Thanks

Greg

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: MPLS VPN Traffic Issue

Hello Greg,

probably there is a problem on the forwarding plane

verify with

sh mpls ldp discovery

if you see correct LDP adjacencies on all MPLS interfaces of core router.

if you don't see the neighbor LDP router-id followed by :0 that link is not working well.

and verify with

sh mpls forwarding PE-loopback-address correct action should a label value or pop tag if you see untagged this breaks the MPLS VPN connectivity.

in that case do shut wait 60 seconds no shut of the link to give LDP a chance to restart on the link

Hope to help

Giuseppe

1 REPLY
Hall of Fame Super Silver

Re: MPLS VPN Traffic Issue

Hello Greg,

probably there is a problem on the forwarding plane

verify with

sh mpls ldp discovery

if you see correct LDP adjacencies on all MPLS interfaces of core router.

if you don't see the neighbor LDP router-id followed by :0 that link is not working well.

and verify with

sh mpls forwarding PE-loopback-address correct action should a label value or pop tag if you see untagged this breaks the MPLS VPN connectivity.

in that case do shut wait 60 seconds no shut of the link to give LDP a chance to restart on the link

Hope to help

Giuseppe

165
Views
0
Helpful
1
Replies
CreatePlease to create content