They said: "You can not configure two static routes to advertise each prefix between the VRFs, because this method is not supported?packets will not be routed by the router. To achieve route leaking between VRFs, you must use the import functionality of route-target and enable Border Gateway Protocol (BGP) on the router. No BGP neighbor is required."
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...