Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

MPLS with Dynamic NAT

I am trying Dynamic NAT to work on 7206. I am using this on my VRF interface. I was able to get static to work, but my MPLS cloud has 30 enpoints and I want all of them to share the same public IP. I will attach my config.

10.20.20.21 is the MPLS site

8.86.131.201 needs to be the NATed IP.

Thanks!

2 REPLIES
Cisco Employee

Re: MPLS with Dynamic NAT

Hi,

I think you should add the overload keywork in your ip nat inside statement to be sure you activate PAT.

Also be sure the remote PE connected to the destination has a route to join 8.86.131.201 for the return path.

HTH

Laurent.

Community Member

Re: MPLS with Dynamic NAT

I opened up a case and found the answer.

Restrictions for Integrating NAT with MPLS VPNs

Inside VPN to VPN with NAT is not supported.

http://www.cisco.com/en/US/docs/ios/ipaddr/configuration/guide/iadnat_mpls_vpns_ps6350_TSD_Products_Configuration_Guide_Chapter.html

187
Views
0
Helpful
2
Replies
CreatePlease to create content