First of all am not running "firewall multiple-vlan-interfaces" so I can creat single L3 in my MSFC and a single L3 can only be a part of single vrf it may be either single vpn vrf or internet vrf ,how can I provide multiple vrf .
Can u explain am not clear about ur above explanation.
Now that was the disconnect, if you are running only a single L3 between the FWSM and the MSFC then you cannot assign more than one VRF.
Although you can assign different RT in that single VRF for different customer subnets inside the FWSM and have the RT's imported into the corresponding VPN;s at other end PE's. Only caveat is you will have to implement NAT somewhere to avoid IP overlaps.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...