So you would want to change the mpls mtu on the PE and P routers to accommodate a full ethernet frame plus the two mpls labels and any other additional info, like control words or vlan tag you might be transferring across the backbone, a value like 1514 would work, but if you ever decide to do straight ethernet to ethernet l2vpn with QinQ, then you would be up to 1530. If you maybe did serial links in the future, you'd maybe be up to 4480-4490.
In most SP environments I've worked it, its standard to set the mpls backbone mpls mtu to 9100 or 9192 at install time to remove any issues with the backbone mtu.
Mpls mtu only affects handling of labeled packets, not unlabeled packets.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...