I have a GSR configured for default MTU (1500) on the Gigabit SPA (5 port SPA). The interface is used to configure EoMPLS tunnel with 7600s. So when a large EoMPLS packet (with IP Payload > 1492) which has PPPoE header reaches this interface, does the GSR drop it or pass through?. As it is a L2 packet it cannot be fragmented. If it drops it can affect the traffic, right? Where can I see the drops in the GSR...I do not see the same in the show interfaces..
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...