Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
Silver

Need MPLS-TE Solution

I want to implement MPLS _ TE.

If my A-D link fails (it is primary link) then i want my traffic will follow the given path

D-B-C-A.

For this i need MPLs-TE configuration.

regards

shivlu

2 REPLIES
New Member

Re: Need MPLS-TE Solution

hello

configure one primary te tunnel D=>A given explicit path, tunnel FRR protected

configure a te tunnel D => A given explicit path DBCA

configure the backup tunnel on interface D=>A

Etienne

New Member

Re: Need MPLS-TE Solution

Hi,

Your intention is to pass traffic between A and D, and want to reroute the traffic via B and C node.

As FRR uses the tunnel in between to tunnel tail , i say if you create two tunnels between A and D as following :

Tunnel 1 : A to D explicit path A - D

Tunnel 2 : A to D explicit path A -C-B -D

and prioritise the tunnel 1, you should achieve the required.

Also note TE tunnels are unidirectional so create resiprocal tunnels for traffic from D to A

Cheers

Prince!

142
Views
0
Helpful
2
Replies
CreatePlease to create content