Excuse me for launching this pre-sales issue, but I have an urgent question and perhaps you can help me quickly or tell me who/where I can find help. I do not know where I can find this simple info quickly.
One customer (carrier) has listened something about a new NPE for Cisco 7200 uBR and has asked for anything that I am not able to answer: Will that new NPE support 2 ports STM-1 PA for backbone conexion? Which is that new NPE?
Please could you help me with this question?
Thanks you very much for your attention in advance.
IntroductionPre-requisite: Caveat :When IPXE Boot could be done : IPXE Boot :Ipxe boot using DHCP Server :
iPXE boot in ASR9K
Migration recommendation document for Cxr to Exr.
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...
Hi community,I just wanted to share my findings about accesing to ACL counters by SNMP on ASR9000/XR.
Searching on Internet I found the section ACL Counters Using SNMP in the IP Addresses and Services Configuration Guide but I didn't found any inf...