We have a requirement to PBR certain traffic on R3 for port 80 (Matching Source IP's) to a certain next-hop. PBR would be applied on R3 on the interface connecting R2&R3 and R4&R3. However all routers are MPLS enabled. Is there any way of achieving this as the traffic is label switched?
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...