Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PE Node Protection

Hi,

Does anyone know of an implemented method to provide PE Node Protection?

Failover time is key here.

Network topology has pair of PEs at each site, with each PE connected to a seperate P. The 2 PEs at each site are connected and link protection is in use today for PE-P link failures.

Thanks Steve

2 REPLIES
Silver

Re: PE Node Protection

When you say Link Protection , iam assuming you are using MPLS TE with fast rerouting enabled. But Re Routing is quite fast ( that is my experience atleast). Maybe you could tweak your IGP timers and check. Perhaps you could elaborate your problem.

Regds

New Member

Re: PE Node Protection

Thanks for your message.

You are correct it is FRR link protection and it is pretty quick, for a link failure.

What I am looking at is PE failure and fast recovery utilising the 2nd PE at that site.

Regards

Steve

222
Views
0
Helpful
2
Replies
CreatePlease to create content