I would like to configure two routers back to back MPLS. Each router has 2 interfaces. One to face the "cloud" and one to face the customer. The cloud is nothing more than a VLAN in which there are no other routers. The 2 MPLS end points are one the same IP segment and actually CDP see each other. I would like to take everything from the customer facing interface, encapsulate it, send it to the neighbor router and strip the MPLS tag and push it out the other non-cloud interface.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...