I need to do some sort of Reliable Policy Routing.
I was thinking about using 1 of the 2 features:
-Policy Based Routing: Recursive Next Hop
-PBR Support for Multiple Tracking Options
Does anyone know exactly how set ip next hop recursive works?
My first go would be sending traffic to a directly connected router, but if this router goes down I would need to send to a another router (I'm using ethernet and a l2 device to connect these 2, so interface could stay up).
So, my question is:
If I set ip next hop recursive IP1 IP2
would it mean that if I cant get to IP1 , I would go to IP2 and these 2 IPs could be not directly connected to my router?
Hope this is not very confusing. I'm trying to better understand this recursive feature.
The configuration does not ensure that packets get routed using the recursive IP address if an intermediate IP address is a shorter route to the destination. For more details regarding the pbr recursive next hop follow the url,
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...