Problem Running ATom (Ethernet) Between a 3750 Metro and a 6500
We are attempting to connect a port on a 3750 metro to a port on a 6500(3BXL) using Atom. We have are currently running MPLS between them and they are doing L3Vpn with vrfs. We attempted to build the connection by issuing xconnect commands between them. The l2 vc appears to come up but traffic does not appear to pass properly. We are running 12.1(14)AX3 on the 3750 metro's , and 12.2(18)SXD5 on the 6500. I noticed that on the 3750 the port must be configured as a layer 2 port and on the 6500 the port must be configured as a routed port to issue the xconnect command. Is it support to do atom between a 3750 metro and a 6500?
Re: Problem Running ATom (Ethernet) Between a 3750 Metro and a 6
Are you sure you can only configure ATOM on the ES ports? I was able to configure ATOM beween a pair of the 3750's and it seemed to work fine from the standard ethernet ports. Doesnt make much since that you would only be able to configure atom on the ES ports since that wouldnt be very usefull.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...