Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QOS on DS3 to Ethernet backbone, MPLS needed?

I don't have much knowledge on MPLS, but I have a scenario and need some help.

We are going to use an existing Microwave Network that consists of 20 hub sites configured in a ring topology and one of the DS3 channels to transport Ethernet traffic (with the help of media converters). My question is if we wanted QOS (Quality of Service) and wanted to prioritize voice traffic over data, do we really need MPLS? Will MPLS improve the performance of the already existing DiffServ Architecture defined by RFC2475, or does MPLS mearly just support DiffServ Architecture as defined in RFC3270?

Please help me out in answering my questions so we don't venture into technology we don't really need to support our customer.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: QOS on DS3 to Ethernet backbone, MPLS needed?

hi Nolan

let me clearify things to u

MPLS is a technology that used to make forwarding faster instead of forwarding packets based on routing table with MPLS the packet will be forwarded based on label switching which is faster easpecially for service provider networks

QoS is a mechnizem for bandwidth managment

so they both completely diffrent

and about DSCP it is the bits on the TOS ip header that used to mark traffic

while with mpls network the marking will be based on mpls exp which is not DSCP

so they are not related at all but work and coexist together in other words u can impliment MPLS with QOS but not MPLS implimented to imporve QOS or VOIP !!

so if u look only for QoS and voice priority then u dont need MPLS

good luck

if helpful Rate

1 REPLY

Re: QOS on DS3 to Ethernet backbone, MPLS needed?

hi Nolan

let me clearify things to u

MPLS is a technology that used to make forwarding faster instead of forwarding packets based on routing table with MPLS the packet will be forwarded based on label switching which is faster easpecially for service provider networks

QoS is a mechnizem for bandwidth managment

so they both completely diffrent

and about DSCP it is the bits on the TOS ip header that used to mark traffic

while with mpls network the marking will be based on mpls exp which is not DSCP

so they are not related at all but work and coexist together in other words u can impliment MPLS with QOS but not MPLS implimented to imporve QOS or VOIP !!

so if u look only for QoS and voice priority then u dont need MPLS

good luck

if helpful Rate

327
Views
5
Helpful
1
Replies