Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QoS Setup issue

When setting up QoS on a 2801, I get the following error when trying to apply the service-policy to the interface.

I/f Serial0/1/0:0 class CRITICAL requested bandwidth 49%, available only 25%

The service provider only provides me with a 50%/49% QoS policy to work with. Attached is the QoS config I'm trying to use. Every time I try to run the last step, I get the same error.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: QoS Setup issue

Hi

by default it is possible to reserve 75%, with 25% avaliable for default class.

command max-reserved-bandwidth changes default

Try

int ser 0/1/0:0

max-reserved-bandwidth 99

Service-policy out xxx

Jon

1 REPLY
New Member

Re: QoS Setup issue

Hi

by default it is possible to reserve 75%, with 25% avaliable for default class.

command max-reserved-bandwidth changes default

Try

int ser 0/1/0:0

max-reserved-bandwidth 99

Service-policy out xxx

Jon

108
Views
0
Helpful
1
Replies