Questions stemming from the unidirectional nature of MPLS LSP
After reading the following excerpt, I have some questions that I hope someone could clear up for me.
"An MPLS connection (LSP) is unidirectional—allowing data to flow in only one direction between two endpoints. Establishing two-way communications between endpoints requires a pair of LSPs to be established. Because 2 LSPs are required for connectivity, data flowing in the forward direction may use a different path from data flowing in the reverse direction."
Suppose I have a Network Management Station at each of the two geographically dispersed Data Centers, carrying out identical SNMP/ICMP-based monitoring against the same remote router at a third Data Center that's connected to the first two DCs via MPLS sold by the same ISP. There've been occasions when only one NMS (at say DC_A) reported the router at the third DC "down" (unreachable). Upon seeing the alert, the network operators sitting in DC_B pinged the remote router at DC_C successfully, therefore concluding the NMS was "crying wolf". I had thought it meant there's a problem with the particular MPLS circuit over there. But given the above paragraph about MPLS' unidirectionality, and the fact multiple interruptions in either forward or reverse direction could cause the NMS software to eventually conclude that the remote router has become unreachable, was my original conclusion wrong? What correct conclusions could be drawn from the aforementioned scenario of a single NMS reporting an outage at the other end of the MPLS? Furthermore, is it possible that actual business application traffic flowing through the same DC_A <=> DC_C MPLS could be unimpacted while my NMS there was alerting, due to the former taking a "different path"?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...