Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RSVP signalling under 12.2(33)SB - can't enable hellos

We are using RSVP for signalling for MPLS under 12.2(S)25 and started to move to the SB train - specifically 12.2(SB)33. We are using 7304s.

I can't seem to get global hellos enabled on the SB train and can't establish any adjacencies. Any clues as to why?

1 REPLY

Re: RSVP signalling under 12.2(33)SB - can't enable hellos

Hi,

The RSVP signaling messages are:

1- Path tear.

2- reservation tear.

3- Reservation error.

3- Reservation confirmation.

The RSVP TE tunnel take into account the following needed information.

1- Available bandwidth.

2- Maximum reserved bandwidth.

3- reserved bandwidth.

4- Tunnel destination.

Make sure you enable RSVP and you should be able to get global hellos.

HTH

Mohamed

135
Views
0
Helpful
1
Replies
CreatePlease to create content