Running vrf-lite and dhcp server see 0.0.0.0 as giaddr
Im running vrf-lite and our dhcp server see only 0.0.0.0. Im able to ping vlan10, and see the dhcp request. Running on a 2811. I have limited access to device. Do I need to turn on Dhcp-relay? Verifing ip forward-protocol. Do i need to add " vrf WISP to my helper-address? The interface it sends Dhcp request is also within the vrf. The dhcp scope is part of Vlan10 subnet
int vlan 10 ip vrf forward WISP ip add x.x.x.x s.s.s.192
Re: Running vrf-lite and dhcp server see 0.0.0.0 as giaddr
Yes and no. It uses another interface thats within the same vrf Wisp. On the other end of the vrf it is forwarded to our global dhcp server. in bold is where the unicast packet are going using the defaultroute
int fast0/0.1 encap dot1q 1 ip vrf forwarding WISP ip add 172.16.6.2 255.255.255.252 ! int vlan 10 ip vrf forward WISP ip add 188.8.131.52 255.255.255.192 ip helper-address 184.108.40.206 ! ip route vrf WISP 0.0.0.0 0.0.0.0 172.16.6.1
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...