Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Segment Routing Maximum SID Depth (MSD)

I've a couple of questions on Segment Routing Maximum SID Depth (MSD):

  • Is there a command to configure and view MSD on ASR9K / CRS?
  • If I have a SR-TE tunnel that uses SIDs up to MSD and an L3VPN service using 2 more labels (a VPN label + a BGP-LU label) that uses this SR-TE tunnel, what would the behavior be?

Regards,
Muthu

  • MPLS
2 REPLIES
Cisco Employee

I don't think you are able to

I don't think you are able to configure the MSD. I believe it is hard-coded into the Hardware.

Cisco Employee

MSD depends on the hardware

MSD depends on the hardware platform and it can vary from platform to platform.

Thanks

Sudhir Kumar

1
Views
0
Helpful
2
Replies